Your shopping cart is empty
To setup a Draytek with a Virgin Superhub, you'll first need to put the Virgin Superhub into modem mode. To do so, follow this link: How do I put my Virgin Superhub into modem mode?.
Next, head into the web configuration for the Draytek, which can be accessed via the web address of 192.168.1.1, unless specified differently by your home or business network, using the default username and password of admin to log in.
Navigate to WAN > General down the left hand side, and check that the physical mode/type is set to Ethernet/Auto negotiation for the WAN port you used - in the screenshot below, we have used WAN 2:
Next, go to Wan > Internet Access down the left hand side, and set the Access Mode for the WAN port you used to Static or Dynamic IP. In the screenshot below we used WAN 2 again:
If the above is all correct and saved, reboot your Super Hub; it'll take around a minute for your Draytek to grab an IP address from your Virgin SuperHub once you've rebooted it, however after a short delay you should have internet.
Once connected, we recommend setting up Quality of Service on your Draytek in order to manage your bandwidth efficiently. Our FAQ can guide you through this process.
13 September 2018
Connect your VoIP phones to your network even without a nearby network router. Powerline Adapters are an ingenious solution to extending your WiFi networks. Find out more.
13 February 2019
Easily reduce call abandonment rates and control the flow of calls to your team when you use call queuing with our cloud-based VoIP phone system.
16 January 2019
Introducing BYOD or Bring Your Own Device to your business can help enhance your business and bring increased flexibility and satisfaction to your workforce.